800-752-5470
302-477-1351
Fax 302-477-1083

2409 Chatham Drive
Wilmington, DE. 19803
Home Sani-Mist System Sana-Mist Solution Sani-Mist Dispenser Contact Us

Installation, Operation & Maintenance Of Your SANI-MISTER DISPENSER
Your SANI-MISTER Dispenser package contains:

  • One Sani-Mister Dispenser
  • One Wall Placard
  • Place placard on wall at eye-level.

INSTALLATION

Place your new SANI-MISTER in a shower room at a central location easily accessible to a maximum number of people.

  • The Dispenser should be placed with the pumps closest to the wall.
  • Wipe the wall clean directly above the Dispenser.
  • Place the placard on the wall at eye level.
TO FILL THE SANI-MISTER DISPENSER
  • Remove the treadle lock screw and swing back the treadle, as shown in the diagram.
  • Pour SANA-MISTTM solution into the filler hole, Until the level of solution is 1/2 inch from the top. The tank capacity is approximately two (2) gallons.
  • Replace the rubber stopper.
  • Return the treadle to the normal position and replace the lock screw.

IMPORTANT
Use only SANA-MIST solution,
Any other may adversely affect the dispenser.

SANA-MIST solution should be used full strength.
Be sure the rubber stopper is on at all times so dirt or a dilutant cannot enter the tank.

The SANI-MISTER Dispenser is the ultimate in
mechanical simplicity and should not require any
major repairs. If it should be damaged in use,
call immediately for service.

 TO OPERATE

Ease of operation is a, SANI-MISTER exclusive. Simply step on to both treadles, mark time, and step off. It really is that easy! On the first filling it may take several strokes on each treadle to prime the pumps.
CLEANING INSTRUCTIONS

It, is important to keep the exterior of your SANI- MISTER clean. Placing the Dispenser under a shower every few days, or as needed, can be very effective. If foreign matter should accumulate under the Treadles:
  • Remove the treadle lock screw.
  • Swing the treadles back as shown in the diagram.
  • Wipe the tank and treadles with a clean cloth, or brush.
  • Return the treadles to their normal position and install the lock screw.

The Sani-Mister Dispenser TM Is
Sturdy, Maintenance-Free*, and Fully Guaranteed.

There Are No Loose Parts. • Many of Our Dispensers Have Been Working for Over 10 Years!
Our Sani-Mister Dispenser is Proudly Made in the U.S.A. of Heavy Duty Metal and Plastic.

New dispensers have a full year parts and labor warranty from date of purchase.
Reconditioned Dispensers have 90-day parts and labor warranty from date of purchase.

*We will service your Sani-Mister dispenser if you so desire. Even though it is virtually maintenance-free, after approximately five years of use it will look a little tired. Just send it back to us and we will recondition it for about half the cost of a new one.
Back to Top